please do not use full signature unlock for s1 open with aid 004, when s1 signatures server offline, otherwise credits will be used, but
phone could be unlocked only after s1 signature server will be online
please do not use full signature unlock for a2 model "j108", when s1 signatures server offline, otherwise credits will be used, but
phone could be unlocked only after s1 signature server will be online
You can unlock only A2 based phones through this steps any cid ..
Procedure Step By Step (except spiro & yendo) :-
1. select proper model(from SEMC A2)
2. on settings, check
"signed mode",
"do full unlock instead usercode reset",
"disable flash mode activation for semc a2 phones",
fill login details
3. back to semc a2 tab, press unlock
4. when prompted, install phone modem drivers
(they can be found in drivers\Modem_Drivers or will be automatically installed if you install semc pc suite)
5. when you will get message "unlock done" - do not remove cable or battery,
wait until phone automatically power on, otherwise you will get 5 locks and need to repeat procedure.
Procedure Step By Step for SPIRO & YENDO :-
please check if phone has unlock attempts remaining BEFORE requesting code
if attemps left than do given below steps
signed mode + altbypass = codes, 4 credits
How to enter codes in spiro …?
Enter Codes or want to check left attempts use .. Left key * * left key
How to enter codes in Yendo …?
CHECK SOFTWARE AND CHECK LOCK STATUS
ENTER #987654321# AND SELECT RED AND PUT CODE
MODEL CREDITS
J10_ELM 6
J20-HAZEL 6
W20_ZYLO 6
X5_XPERIA 10
W100 Spiro 4
W150_YENDO 4
SATIO_U1 6
U5_VIVAZ 6
مشكله في فتح شبكه u5-vivaz + j10 elm
رد: مشكله في فتح شبكه u5-vivaz + j10 elm
رد: مشكله في فتح شبكه u5-vivaz + j10 elm
العرض العادي
